"Very ergonomic with a good grip. Love how it connects to the ruler."
– Karen FerDon, verified customer
Most cutting trouble is not one problem. The blade starts to skip, so you press harder. You press harder, so the ruler creeps. The ruler creeps, so the block leaves the mat a sixteenth short, and you square it up and lose the point on the star.
Three tools, one job. That is why they are on one page.
How the three work together
The cutter has a removable TrueCut® guide. It locks into the raised track that runs along both sides of the ruler, so the blade follows the edge instead of wandering off it, and the ruler stops sliding under your hand halfway down a long cut. Prefer the rulers you already own? Take the guide off and it works like any rotary cutter.
The blades
Every blade is titanium coated SKS-7 tungsten steel. The coating is harder than the steel underneath and it cuts friction at the edge, so the edge holds its shape long after an uncoated blade has rounded off. That is why these blades last 6 times longer than a standard brand-name blade. It is not a slogan. It is what the coating does.
Ten in the box, because a blade only helps you on the day it is sharp. You change it the moment it starts to skip, not four days later when the delivery van arrives.
The cutter
The Comfort Curve Grip lines up your wrist, arm and shoulder so the pressure lands where it belongs, directly over the blade, and not in your hand. Blades change with a push button, the safety lock covers the edge the moment you set it down, and the cutter converts for right or left-handed use.
The ruler
Six and a half inches square, the size you reach for most: squaring up blocks, trimming half-square triangles and flying geese, cutting the small shapes that decide whether the points meet. The grid reads in eighth-inch increments, the quarter, half and three-quarter lines are labelled, and there is a 45° line for trimming on the bias. Marking holes let you mark the fabric through the ruler without moving it. It is injection-moulded thermoplastic rather than standard acrylic, so the edges stay straight and chip-resistant through years of cutting.
In the box
- 10 x 45mm titanium coated rotary cutter blades, in a plastic storage container
- 1 x 45mm My Comfort Ergo Cutter with removable TrueCut® guide
- 1 x TrueCut® 6.5" x 6.5" Square Quilting Ruler
Specifications
- Blades: 45mm, round centre hole, the standard fit for rotary cutters
- Blade steel: titanium coated SKS-7 tungsten steel
- Cutter: 45mm, quick-release blade change, safety lock, converts for right or left hand
- Ruler: 6.5" x 6.5", 1/8" grid, 45° line, marking holes, chip-resistant thermoplastic
What it comes to
| 10 x 45mm titanium coated blades |
$75.00 |
| 45mm My Comfort Ergo Cutter |
$43.72 |
| TrueCut® 6.5" x 6.5" Square Ruler |
$19.97 |
| Bought separately |
$138.69 |
| Together on this page |
$75.00 |
You pay for the ten blades and nothing else. The cutter and the ruler are $63.69 on their own pages, and here they come in the same box at no charge.
60 day satisfaction guarantee. Cut with the blades for two months. If you find a blade that beats ours, tell us and we refund you in full. Keep the blades.
Put a fresh blade in the cutter, lock the guide into the ruler track, and make one pass. That is the whole argument, and it takes about four seconds.
